The 60V 500A IGBT Hard Anodizing Power Supply is a unidirectional DC power supply rated at 60 V and 500 A for hard anodizing projects. The published rating defines the available DC envelope; it does not replace process calculations or establish the normal operating setpoint.
Published Rating and Electrical Boundary
| Rated DC output | 60 V DC, 500 A DC |
|---|---|
| Application | hard anodizing |
| Regulation | Constant-current or constant-voltage main mode, selected for the confirmed process |
| AC input | AC 380 V or 415 V. Final phase, frequency and site conditions must be confirmed. |
This product follows Gao Hui’s low-voltage AC input, high-frequency switching and isolation, one-way DC architecture. It is not presented as an external DC-input converter, AC-output source, bidirectional or regenerative supply, or medium/high-voltage direct-input system.
Application and Selection
This page applies to engineering hard-coat anodizing for a defined aluminum alloy, film thickness and production cycle Use effective area and the hard-anodizing current density supplied by the validated process; check the maximum production load. Voltage commonly rises as the oxide film grows, so the start point, maximum voltage and approved ramp must be confirmed.
Hard anodizing is not the same as conventional decorative anodizing or plasma electrolytic oxidation.
Production-window focus: size against the credible maximum load while preserving useful adjustment through normal production. Minimum, normal and maximum conditions should be supplied together.
Information Required for Selection
- aluminum alloy
- effective area and load
- hard-coat chemistry
- current density
- target thickness and cycle
- starting and maximum voltage
- ramp profile
- bath temperature, cooling and duty
Also provide the site AC voltage, phase and frequency; cable distance; daily duty; ambient conditions; cabinet location; required local or remote control; and any interface or interlock list. Gao Hui engineering can then check the practical working range against the published rating.
Configuration Boundary
The confirmed standard scope is limited to the published DC rating and stated process use. Cooling method, enclosure, control interface, ramp, timer, ampere-hour control, pulse waveform, polarity reversal, communications, ripple target and redundancy are project-specific. They are supplied only when written into the confirmed configuration and must not be inferred from a legacy title, image or category.
Frequently Asked Questions
Is the rated current the normal process current?
No. The rating is the product ceiling; the working setpoint must follow the validated process window and actual load.
Can the process name determine the final voltage?
No. Loaded voltage depends on chemistry or load behavior, spacing, contacts, conductors and the production arrangement.
Are pulse, reversal and communications included?
Only when they are written into the confirmed configuration. They are not assumed from the product title.
Review related options in Anodizing Rectifiers, or contact Gao Hui with the selection data above.
Reviews
There are no reviews yet.